You can find plenty of AI-generated concept cars online, usually accompanied by a convincing but completely fictional backstory. The funny thing is, the real automotive archives have more than enough material to compete.

A Ferrari with a sliding roof instead of doors. A Citroën shaped like a pyramid. A six-wheeled Ford designed with nuclear power in mind. These were actual projects from major manufacturers and design studios, dating back as far as the 1950s.

Some were fully operational. Others never made it beyond the motor show floor. All ten are real.

1970 Ferrari 512 S Modulo
1970 Ferrari 512 S Modulo

1

1970 Ferrari 512 S Modulo

Paolo Martin designed the Modulo for Pininfarina using the chassis of a Ferrari 512 S endurance racer. That meant a 5.0-liter V12 with a claimed 550 horsepower was sitting underneath one of the flattest bodies ever fitted to a car.

At just 36.8 inches (935 mm) tall, the Modulo had partially covered wheels, almost no conventional side windows, and a roof that slid forward to let the driver climb inside. The row of holes across the rear deck provided ventilation for the engine.

Pininfarina showed it at Geneva in 1970, but the car wasn't operational at the time. Collector Jim Glickenhaus acquired it decades later and had it restored to running condition. So yes, somebody actually drives this thing.

1980 Citroën Karin
1980 Citroën Karin

2

1980 Citroën Karin

Citroën's Karin was essentially a pyramid on wheels, right down to its tiny roof. The roof panel was reportedly no larger than a sheet of A3 paper.

Designed under Trevor Fiore for the 1980 Paris Motor Show, the Karin accommodated three people in an unusual arrangement: the driver sat in the middle, slightly ahead of two passengers. Most of the controls were grouped around the steering wheel, with electronic instruments replacing the usual dashboard layout.

Citroën wasn't proposing the Karin as its next family sedan. It was a design exercise, built at a time when the company was looking for new styling directions. That freedom probably explains the shape.

1970 Lancia Stratos Zero
1970 Lancia Stratos Zero

3

1970 Lancia Stratos Zero

The Stratos Zero stood just 33 inches (84 cm) high. Getting inside required opening the entire windshield and climbing over the nose. Once seated, the driver looked out over a sharply pointed front end that was almost level with the road.

Marcello Gandini designed it at Bertone, using the mechanical components of a Lancia Fulvia HF, including its 1.6-liter V4 engine.

The car made its debut at Turin in 1970, two years before the production Stratos appeared. Bertone even demonstrated that the Zero could be driven on public roads. There's a famous story of Nuccio Bertone driving it beneath the entrance barrier at Lancia's headquarters, an excellent way to get an automaker's attention.

1972 Maserati Boomerang
1972 Maserati Boomerang

4

1972 Maserati Boomerang

Giorgetto Giugiaro's Maserati Boomerang took the wedge-car trend about as far as it could go. Nearly every surface was flat, with steeply angled glass and a front end that looked as though it had been cut with a straightedge.

The engineering was surprisingly conventional. Under the body was a Maserati Bora chassis with a mid-mounted 4.7-liter V8 producing around 310 horsepower.

Inside was a different story. Giugiaro placed the instruments and switches in a large fixed hub at the center of the steering wheel. The rim rotated around it, leaving the gauges directly in front of the driver.

After appearing as a static model in 1971, the Boomerang was completed as a running car for the 1972 Geneva Motor Show.



1968 Alfa Romeo Carabo
1968 Alfa Romeo Carabo

5

1968 Alfa Romeo Carabo

Before the Lamborghini Countach had scissor doors, there was the Alfa Romeo Carabo.

Bertone built the Carabo on the chassis of an Alfa Romeo 33 Stradale, using its mid-mounted 2.0-liter V8. Marcello Gandini designed the body, giving it an extremely low nose, sharply angled windshield, and doors that swung upward instead of outward.

It debuted at the 1968 Paris Motor Show in metallic green with orange-tinted glass. The name came from the Carabidae family of beetles, which also inspired its iridescent coloring.

You can see quite a bit of the later Countach in the Carabo's proportions and detailing. Gandini designed both, although the Alfa arrived roughly three years earlier.

1962 Ford Seattle-ite XXI
1962 Ford Seattle-ite XXI

6

1962 Ford Seattle-ite XXI

Ford unveiled the Seattle-ite XXI at the 1962 World's Fair, and the specification sheet was considerably stranger than the bodywork.

The concept had six wheels, with four at the front, and was designed around an interchangeable power module. Ford imagined a future where different propulsion units could be fitted to suit different journeys. Its designers even considered fuel cells and compact nuclear power.

Other proposed equipment included computerized navigation, variable-opacity glass, and fingertip controls.

There's one important distinction: the Seattle-ite XXI was a 3/8-scale styling model, not a functioning six-wheeled car. The engineering existed largely on paper, but Ford went far enough to give the public a detailed look at the idea.

1958 General Motors Firebird III
1958 General Motors Firebird III

7

1958 General Motors Firebird III

GM built three experimental Firebird vehicles during the 1950s, each taking more inspiration from aircraft than the last. The third was probably the strangest.

Its fiberglass body had seven fins, prominent air intakes, and separate bubble canopies for the driver and passenger. A gas-turbine engine producing approximately 225 horsepower provided propulsion.

Rather than a steering wheel and pedals, GM fitted a joystick-like control system called Unicontrol. Moving the stick operated the steering, throttle, and brakes.

This wasn't just a styling model. The Firebird III was an operating experimental vehicle, developed to explore alternative propulsion and driver controls. GM built it in 1958 and displayed it publicly in 1959.

1986 Peugeot Proxima
1986 Peugeot Proxima

8

1986 Peugeot Proxima

Peugeot unveiled the Proxima at the 1986 Paris Motor Show with a claimed 600 horsepower from a twin-turbocharged 2.8-liter V6.

The engine sat behind the occupants, beneath an exposed rear section that showed off much of the mechanical hardware. The car also used an electronically controlled all-wheel-drive system capable of engaging the front wheels when rear-wheel traction was lost.

Inside, Peugeot installed five color displays, two onboard computers, navigation equipment, and cameras that helped the driver see what was happening behind the car. Solar cells supplied power for the cabin ventilation system.

All this was packaged beneath a huge glass canopy. The Proxima looked particularly unusual from the rear, where the enclosed passenger compartment gave way to exposed engine hardware and mechanical components.

1988 Italdesign Aztec
1988 Italdesign Aztec

9

1988 Italdesign Aztec

For Italdesign's 20th anniversary, Giorgetto Giugiaro came up with a sports car whose driver and passenger sat in separate cockpits.

Each occupant had an individual canopy, and microphones allowed them to communicate. The passenger even had a steering-wheel-shaped control panel for operating onboard equipment.

The mechanical components came from rather more familiar sources. Power was supplied by a turbocharged Audi five-cylinder engine, while the all-wheel-drive system used hardware associated with the Lancia Delta HF Integrale.

The Aztec appeared at the 1988 Turin Motor Show and subsequently entered limited production. A small number were built for customers, which makes it one of the rare examples of a concept this unusual actually reaching the road.

1992 Italdesign Columbus
1992 Italdesign Columbus

10

1992 Italdesign Columbus

The Italdesign Columbus was Giugiaro's take on a luxury people carrier, built in 1992 to mark the 500th anniversary of Christopher Columbus's voyage to the Americas.

It was nearly 20 feet long, with an enormous windshield, a high-mounted central driving position, and room for up to nine occupants. Underneath sat a 5.0-liter BMW V12 producing around 300 horsepower, connected to a permanent all-wheel-drive system. Four-wheel steering helped deal with its considerable size.

The cabin was equipped with individual video monitors, television and VHS equipment, and fiber-optic lighting. Seats could be removed or rearranged depending on how the vehicle was being used.

Italdesign imagined the Columbus as an alternative to a conventional luxury limousine. The result looked like someone had combined a minivan with the upper deck of a passenger aircraft.

Strange ideas, real cars

It's worth remembering just how much work went into these projects. Some manufacturers spent years developing experimental vehicles that would never go into production. Others handed established mechanical platforms to designers and gave them almost complete freedom over the bodywork.

A few ideas survived. The Carabo's scissor doors helped establish a feature that Lamborghini would eventually make famous. Digital instruments, cameras, head-up displays, and electronically controlled drivetrains all found their way into production cars.

The nuclear-powered Ford never got very far, but that's probably just as well.

And if these ten seem improbable, there are plenty more buried in the archives.

10 Concept Cars That Look AI-Generated (But Are Real)